Turbo Engine CBA 2 TDI for A3 YETI EOS GOLF 6 JETTA 3 PASSAT SCIROCCO 3 2.0

  
TURBOCHARGER DESIGNED FOR MOTORIZATION 2.0 TDI 140HP AUDI A3 (8P) 2.0 TDI SKODA YETI (5L) 2.0 TDI VOLKSWAGEN EOS, GOLF PLUS, GOLF V, GOLF VI, JETTA III, PASSAT B6, SCIROCCO III, TIGUAN 2.0 TDI. Brand new turbo (no deposit). 1 x Variable geometry turbocharger. A turbocharger, also known as a "turbo" or "turbocharger" in English, is a supercharging system used on internal combustion engines in cars to increase their power and efficiency. 1 Drain the engine oil by adding a pre-drain engine cleaner and replace the oil filter twice in a row: The engine oil must be at temperature. The vehicle must be on a horizontal plane (lengthwise and widthwise). Loosen the oil filter so that the oil can drain completely. Remove the filling cap and the oil dipstick. Let the oil drain through the lower sump. Do not drain by suction! 2 Clean: Clean the oil cooler and the engine side filter completely with brake cleaner and dry the parts with compressed air. Clean the vacuum pump strainer with brake cleaner and dry everything with compressed air. IMPORTANT: If the oil appears polluted, the system must be rinsed before continuing.

For vehicles with less than 60,000 km, the lower engine sump must be cleaned. For vehicles with more than 60,000 km, the lower engine sump must be replaced and the oil strainer must be changed. 3 Check/replace oil line: Replace the oil feed hose with a new one. Replace the hollow screw of the oil inlet and its seals. Replace the oil return hose, its connector, and seals.

IMPORTANT: Check in the hollow screw that the pre-priming filter has been removed and does not remain in the block. 4 Fill with oil and test: Replace the oil filter with a new one. Reassemble the drain plug with a new gasket.

Fill the engine oil up to the correct level. Position the oil return hose in a suitable collector tray.

Start the engine and let it run for 60 seconds at idle. The amount of oil drained must be more than 500ml during the 60 seconds. IMPORTANT: Do not start the engine if the oil level is below the minimum. 5 Fill the oil: Correctly connect the new oil return hose to the turbo.

Fill the engine oil to the required amount. Let the engine run at idle until the oil pressure light goes out for a maximum of 1 minute. Stop the engine and let it sit for 5 minutes.

Check the oil level on the dipstick. It should be close to the maximum, without exceeding it. 6 Additional checks: Visual check of the injectors, if there is soot, this may indicate a leaking injector.

Solve the problem before continuing. If polluted, it must be cleaned or replaced. Check the particle filter and replace if necessary. For right-hand drive vehicles (RHD). For left-hand drive vehicles (LHD).

White or blue smoke coming from the exhaust pipe. For 2.0 TDI with engine codes CBAA, CBAB.

AUDI: 03L253010C, 03L253016F, 03L253019A, 03L253019J, 03L253019T, 03L253056A SEAT: 03L253010C, 03L253016F, 03L253056A SKODA: 03L253010C, 03L253016F, 03L253056A VW: 03L253010C, 03L253016F, 03L253016J, 03L253019A, 03L253019J, 03L253019T, 03L253056A Other OEM: BV43B. 1968 ccm, 100 KW, 136 HP.

1968 ccm, 103 KW, 140 HP. 2.0 TDI 16V quattro. 1968 ccm, 81 KW, 110 HP. 1968 ccm, 105 KW, 143 HP.

2.0 TDI 16V 4motion.